Yes it works for either the older 2 or 3 cylinder 15" mids this is a cut down long shaft swivel from the same era.
| HPBCANADA.COM http://www.hpbc.ca/ |
|
| 93 tilt/trim evinrude 40 http://www.hpbc.ca/viewtopic.php?f=19&t=3373 |
Page 1 of 1 |
| Author: | Deweysdad [ May 18th, 2016, 9:22 am ] |
| Post subject: | 93 tilt/trim evinrude 40 |
Wondering what style clamp and tilt/trim system was used on these motors? And if anyone has tried one on a 3 cylinder shorty instead of the pro50 clamp. It is a much lighter option and omc if it works Lemme know guys |
|
| Author: | Hevi Kevi [ May 18th, 2016, 11:54 am ] |
| Post subject: | Re: 93 tilt/trim evinrude 40 |
I never tried it but it looked like a doable option. The motor was worth too much to me to hack up though. |
|
| Author: | LittleCharger [ May 18th, 2016, 6:33 pm ] |
| Post subject: | Re: 93 tilt/trim evinrude 40 |
Yes it works for either the older 2 or 3 cylinder 15" mids this is a cut down long shaft swivel from the same era. |
|
| Author: | Deweysdad [ May 18th, 2016, 7:37 pm ] |
| Post subject: | Re: 93 tilt/trim evinrude 40 |
What other mods need to be done to the swivel other than getting bushings made to fit the stinger style swivel pin? It already looks close |
|
| Author: | LittleCharger [ May 18th, 2016, 10:29 pm ] |
| Post subject: | Re: 93 tilt/trim evinrude 40 |
Trim/fit the swivel...bushings top and bottom...may have to relocate where the bottom of trim pump attaches to the brackets in order that there is enough clearance for the saddle that attaches the bottom of the mid has clearance when the trim is always down. That's about it. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |