| HPBCANADA.COM http://www.hpbc.ca/ |
|
| Engine Height & water pickup without Low Water Pickups http://www.hpbc.ca/viewtopic.php?f=19&t=4455 |
Page 1 of 1 |
| Author: | Hounddog [ August 30th, 2023, 3:32 pm ] |
| Post subject: | Engine Height & water pickup without Low Water Pickups |
This video of an SST.60 on a commercial 13 foot tunnel demonstrates just how high you can run an outboard with stock water pickups on the gearcase. It seems like a mistake that the driver leaves his power jack plate in the high position at the start of the video. You can see the water pickups on the side of the gearcase. The motor is getting water from the spray off the boat. The driver then lowers the motor down about 2.5 inches . https://www.youtube.com/watch?v=ShVWzIO4MDg |
|
| Author: | LittleCharger [ August 30th, 2023, 9:42 pm ] |
| Post subject: | Re: Engine Height & water pickup without Low Water Pickups |
Kyle actually ran an external pickup on that set up all the stock water pick ups where filled in |
|
| Author: | Hounddog [ August 30th, 2023, 10:48 pm ] |
| Post subject: | Re: Engine Height & water pickup without Low Water Pickups |
The pickup tube must be connected on the other side. Sure enough.....here it is! https://www.screamandfly.com/showthread ... nnel/page6 |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |