| HPBCANADA.COM http://www.hpbc.ca/ |
|
| evinrude decals http://www.hpbc.ca/viewtopic.php?f=2&t=4296 |
Page 3 of 3 |
| Author: | mattmak [ March 22nd, 2020, 10:21 am ] |
| Post subject: | Re: evinrude decals |
MarkStein wrote: Hounddog wrote: I bet Zach has Tim's 60 hp OMC with yamaha trim?? Here are the decals for the motor. http://johnsondecals.com/outboard/evinr ... s-set.html That could be the one. Paul picked it up for us and its there now being prepared. 
|
|
| Author: | DoktorC [ March 22nd, 2020, 12:20 pm ] |
| Post subject: | Re: evinrude decals |
If you want it to run..... |
|
| Author: | mattmak [ March 22nd, 2020, 1:08 pm ] |
| Post subject: | Re: evinrude decals |
DoktorC wrote: If you want it to run..... I suppose there may be some evidence that this may be true. But how can you trust a guy who doesn't have his own prop wrench..? |
|
| Author: | DoktorC [ March 22nd, 2020, 1:33 pm ] |
| Post subject: | Re: evinrude decals |
mattmak wrote: DoktorC wrote: If you want it to run..... I suppose there may be some evidence that this may be true. But how can you trust a guy who doesn't have his own prop wrench..? Who needs a prop wrench when you're always going forward....prop nuts are weight... |
|
| Author: | mattmak [ March 27th, 2020, 7:33 pm ] |
| Post subject: | Re: evinrude decals |
Oh... My bad, my bad.. I wasn't thinking Paul TopGun Paul.. I was thinking Paul "OMC's can suck so hard, watch your decnals" Paul, who always needs to borrow a prop wrench. Sorry Disco! I only really know you by Disco from all the famous callouts at races. |
|
| Author: | LittleCharger [ March 28th, 2020, 7:12 am ] |
| Post subject: | Re: evinrude decals |
mattmak wrote: Oh... My bad, my bad.. I wasn't thinking Paul TopGun Paul.. I was thinking Paul "OMC's can suck so hard, watch your decnals" Paul, who always needs to borrow a prop wrench. Sorry Disco! I only really know you by Disco from all the famous callouts at races. prop wrench minor detail it's just an excuse to walk around and see what prop your putting on 
|
|
| Page 3 of 3 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |