| HPBCANADA.COM http://www.hpbc.ca/ |
|
| trim guage install wiring on a ox66 http://www.hpbc.ca/viewtopic.php?f=2&t=3422 |
Page 1 of 1 |
| Author: | ONTBULLET [ June 28th, 2016, 6:48 am ] |
| Post subject: | trim guage install wiring on a ox66 |
What wire do you splice into on 10 wire harness from an ox66 to connect a trim Guage to? |
|
| Author: | DoktorC [ June 28th, 2016, 8:22 am ] |
| Post subject: | Re: trim guage install wiring on a ox66 |
ONTBULLET wrote: What wire do you splice into on 10 wire harness from an ox66 to connect a trim Guage to? It's not in the 10 wire harness...it's in the 4-wire accessory harness. I don't remember which wire does what though. |
|
| Author: | ONTBULLET [ June 28th, 2016, 10:50 am ] |
| Post subject: | Re: trim guage install wiring on a ox66 |
so a separate 4 wire harness is required for a trim gauge ? There is or should be a connector under the cowling for this harness ? |
|
| Author: | DoktorC [ June 28th, 2016, 12:22 pm ] |
| Post subject: | Re: trim guage install wiring on a ox66 |
ONTBULLET wrote: so a separate 4 wire harness is required for a trim gauge ? There is or should be a connector under the cowling for this harness ? Should be a separate connector for both the Trim and the oil level.. |
|
| Author: | dubber [ June 28th, 2016, 7:23 pm ] |
| Post subject: | Re: trim guage install wiring on a ox66 |
Dok are there also not dip switches to set on the trim gauge assuming a Yamaha multi function tach is used? Raising it as I have popped these senders due to incorrect settings. I have not been in the OX66 motors before though so it may not be the same as the 2.6Ls. |
|
| Author: | ONTBULLET [ June 28th, 2016, 8:49 pm ] |
| Post subject: | Re: trim guage install wiring on a ox66 |
There is three wires that come off the sensor and then goes into a 4 pin connector with a grey wire joining in with the three and then it connects to 4 different colours going out the other side and not sure where they go as they go into the motor harness. Don't see any empty connectors begging for a connection to the gauge. |
|
| Author: | beavertonae-21 [ June 28th, 2016, 10:01 pm ] |
| Post subject: | Re: trim guage install wiring on a ox66 |
I have a brand new three wire Yamaha pro series trim gauge if any one wants one. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |