Well started taking a good look at the boat, getting ready to put the motor back on. After the 3 hour trailer ride home i noticed a few holes that were filled started cracking threw. So got out the sand paper and sanded out the primer. Going to grind out around them and lay in some glass so it dosent happen again
After 34 years of having big power bolted on the transoms showings its age. It was resently done but the out fit that did it must not have clamped on a straight edge. Hard to see in the pic but there the motor bolts is low and in the middles a big high spot. It straightens out about halfway down. Gonna sand out some of the high spot and then lay up some glass in the low spots to even it out. Not gonna go to crazy on it just going to tune it up a bit. I out lined on the back were it needs to be fixed, about a 1/4" difference from low to high
